Next message: Dan Schwartz: "RE: [WinMac] automount Mac SCSI HD update"
Well I finally found that I could check the box for automount if I
highlighted the disk's name in the Drive Setup program. That didn't
help any though.
Then I swapped the SCSI cable around ( as per Bruce Johnson's
suggestion) so that the zip disk was in the middle of the SCSI chain and
the new Quantum HD at the end. That worked...until I mounted the drives
in the computer! So I finally just put SCSI Probe into the Control
Panels and that is automatically mounting the Quantum for me. That
little utility is what I was using to mount the Quantum after the Mac
booted and you can use it in the Control Panel to make a stubborn drive mount.
--
Tom Roth • tomroth@wfubmc.edu • tel 336.716.4493
Wake Forest University School of Medicine
Dept of Biomedical Communications
Medical Center Blvd • Winston-Salem, NC 27157-1011
http://www.wfubmc.edu/biomed/
*** Windows-MacintoshOS Cooperation List ***
FAQ: http://www.darryl.com/winmacfaq/
Archive: http://www.darryl.com/winmac/
To unsubscribe, send mail to winmac-unsubscribe@iffy.com
This archive was generated by hypermail 2b29
: Wed Nov 22 2000 - 12:27:54 PST